Lost Buddy Procedure
Losing sight of your buddy happens to nearly every diver at some point -- a silty bottom, a photo stop, a current that pushes you apart for a few seconds longer than expected. What matters isn't that it happened; it's whether you and your buddy agreed on what happens next before you got in the water. This page covers the shape of a lost-buddy procedure most agencies teach, and how to turn it into a separation plan your team actually agrees on, instead of improvising at depth.

A slow 360° turn before swimming anywhere
Agree the time limit before the dive, not during the search
Ascend safely and mark your position if you still haven't found them
Boat crew or shore support know to watch for a lone diver
Confirm both divers -- and the whole team -- are present
Talk through why it happened before the next dive
The procedure most agencies teach, in outline
Training agencies word it slightly differently, but the shape is consistent: stop where you are, do a slow turn to look around, search briefly within an agreed time limit, then ascend safely if you haven't found your buddy. The exact search window and what happens on the ascent vary by agency, by operator, and by the conditions of the dive -- which is exactly why this needs to be agreed on dry land, not debated underwater.
Write the separation plan before you dive, not during it
- How long to search before ascending -- a specific number, not "a little while"
- Whether to skip the safety stop on that ascent, or hold it if your no-fly and deco time allow
- Where to surface and wait -- the entry point, the boat, a visible landmark
- What signal to give the surface crew if you've surfaced alone
- What a group of three or more does differently than a pair
Why this keeps coming up
Buddy separation is one of the most frequently discussed scenarios on diver forums, and it shows up often enough in incident data that it's not treated as a rare fluke -- not because divers stop caring about their buddy, but because nobody stated the plan clearly enough for it to hold up under a real, disorienting moment. A written plan removes the improvising, the same way the rest of a dive plan does.
What this page is not
This isn't a replacement for your certifying agency's own procedure, and it isn't a rescue-diver course. Follow what you were trained on; use this to make sure your buddy or team agreed on the same thing before you got in the water, instead of each assuming the other would handle it.
Frequently asked questions
How long should I search for a lost buddy before surfacing?
There's no single number that applies to everyone -- agencies teach roughly similar windows, but your own training, the visibility, and the site should set the specific figure for your dive. The point of a separation plan is agreeing on that number before you dive, so nobody's deciding it in the moment.
Should I skip my safety stop if I lose my buddy?
Follow your training and your dive computer. Some operators advise skipping a safety stop on a short, no-decompression dive in order to search or signal faster; others don't. This is exactly the kind of detail worth settling as part of your pre-dive plan rather than during a stressful ascent.
What's different about losing a buddy in a group of three or more?
With more than one buddy, decide in advance whether the remaining divers stay together or also separate to search -- splitting an already-separated group tends to make the situation worse, not better.
Dive Backup organizes information entered by the dive team. It does not calculate whether a dive is safe or replace training, certification, professional judgment, dive computers, agency standards, or a live predive briefing.
Filling this in on paper works until conditions change or a diver drops out. Dive Backup turns it into a shared, reviewable plan your whole team can see, so nothing gets decided verbally and forgotten.
Try Dive Backup freeNo signup to start -- free forever for a single diver
